Operation Manualfor model VR2500Part No. A08955 Rev. 0 11/16/04IMPORTANTPlease make certain that the person who is to use this equipment carefully
10- ENG A089558. Start engine. See Engine Owners Manual for correct procedure. NOTE: When engine rope is pulled, pressure starts building in the gun.
11- ENGA08955HOW TO CLEAN THE WATER INLET FILTERThis screen filter should be checked periodically and cleaned if necessary.1. Remove filter by grasping
12- ENG A089554. Add *RV antifreeze to hose as shown.5. Pull engine starter rope slowly several times until antifreeze comes out of high pressure h
13- ENGA08955TROUBLE SHOOTING GUIDEPROBLEMEngine will not start (see Engine Manual for further engine troubleshooting)No or low pressure (initial use
14- ENG A08955Water leaking at pumpWater leaking at gun/spray wand connectionNo or low pressure (after period of normal use)PROBLEMCAUSECORRECTIONSpr
15- ENGA08955NOTES
16- ENG A08955LIMITED WARRANTYDeVilbiss Air Power Company warrants to the original purchaser who uses the product in a consumer application (personal,
2- ENGA08955IMPORTANT SAFETY INSTRUCTIONSDo not operate this unit until you have read and understand this Operators Manual and the Engine Owners Manua
3- ENGA08955• Materials placed against or near the pressure washer can interfere with its proper ventilation features causing overheating and possibl
4- ENGA08955• Contact with hot surfaces, such as engines exhaust components, could result in serious burn.• During operation, touch only the control
5- ENGA08955• Reactive force of spray will cause gun/wand to kickback, and could cause the op-erator to slip or fall, or misdirect the spray. Imprope
6- ENGA08955Operation Manual b. Secure accessories panel assembly to handle with screws. Do not overtighten.NOTE: The pump on this unit is maintenan
7- ENGA08955OPERATING INSTRUCTIONSBASIC ELEMENTS OF A PRESSURE WASHERHigh Pressure Pump (located inside the shroud): Increases the pressure of the wat
8- ENGA08955PRESSURE WASHER OPERATING FEATURESPRESSURE ADJUSTMENTSThe pressure setting is preset at the factory to achieve optimum pressure and cleani
9- ENGA08955READ AND UNDERSTAND ALL WARNINGS BEFORE STARTING UNITWhen using the high pressure setting, DO NOT allow the high pressure spray to come in
Comments to this Manuals