DeVillbiss Air Power Company 102D-3 Operator's Manual download pdf (Page 16)

16- ENG

D26368

Before Starting

Break-in instructions

Serious damage may result if the following break-in

instructions are not closely followed.

This procedure is required before the air compressor is put into service and

when the check valve or a complete compressor pump has been replaced.

1. Make sure the On/Auto/Off lever is in the "OFF" position.

NOTE: If quick connect is installed, pull coupler back until it clicks to prevent

air from escaping through the quick connect.

Plug the power cord into the correct branch circuit receptacle.

(Refer to

Voltage and Circuit Protection paragraph in the Installation section of this

manual.)

3. Open the drain valve fully to permit air to

escape and prevent air pressure build up in

the air tank during the break-in period.

NOTE: Always drain tank on a washable surface

or in a suitable container to prevent damaging or

staining surfaces.

4. Move the On/Auto/Off lever to "ON/AUTO" position. The compressor will

start.

5. Run the compressor for 15 minutes. Make sure the drain valve is open and

there is minimal air pressure build-up in tank.

6. After 15 minutes, close the drain valve. The

air receiver will fill to “cut-out” pressure and

the motor will stop.

The compressor is now ready for use.

Open Drain

Valve

Closed Drain

Valve

Open Drain

Valve

Closed Drain

Valve

Before Each Start-Up:

1. Place On/Auto/Off lever to "OFF".

2. Turn the regulator knob counter-clockwise to set the outlet pressure to

zero.

3. Attach hose and accessories. NOTE: The hose or accessory will require a

quick connect plug if the air outlet is equipped with a quick connect socket.

Risk of Bursting. Too much air pressure causes a hazardous

risk of bursting. Check the manufacturer’s maximum

pressure rating for air tools and accessories. The regulator outlet pressure

must never exceed the maximum pressure rating.

How to Start:

1. Turn the On/Auto/Off lever to "AUTO" and allow tank pressure to build.

Motor will stop when tank pressure reaches "cut-out" pressure.

2. Turn regulator knob clockwise to increase pressure and stop when desired

pressure is reached.

The compressor is ready for use.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

DeVillbiss Air Power Company 102D-3 Operator's Manual Page 16

Comments to this Manuals

Related products and manuals for Air compressors DeVillbiss Air Power Company 102D-3